Posted Bynick serhan on December 05, 2002 at 00:29:23:
In Reply to: 14 bolt posi posted byandy on October 26, 2002 at 17:37:07:
: : For Sale:
: : 9" 31-spline Detroit Locker
: : Had very little use, just disassembled, cleaned, and checked. Is in excellent condition and ready to use. Asking $375 and I'll pay shipping anywhere in the lower 48 states.
: : Early Chevy 8.2 Pumpkin Style Posi
: : For Sale: Early Chevy Factory 8.2 Front loader Pumpkin Style Posi unit, 17-spline series #4 fits 55'-64' Chevy and 55'-62' Corvette's. Just gone through, excellent clutches, no wear, nice tight unit ready to go. Hard and rare unit to find, this is the one that has duel clutch packs. Asking $500 OBO.
: : Chrysler Dodge Plymouth 9-1/4 Posi
: : Trac-loc posi unit for 9-1/4 Chrysler, Dodge, and Plymouth rear ends. This was just taken apart, cleaned, and inspected and has new clutches installed, it's in excellent ready to use condition. Asking $150 OBO.
: : Chrysler Dodge Plymouth 8-1/4 Posi
: : 8-1/4 Posi for Chrysler, Dodge, Plymouth. This was just taken apart, cleaned, and inspected and is in excellent ready to use condition. Asking $125 OBO.
: : GM/Chevy 14 Bolt Gov Lock Posi
: : Gov lock posi unit from a 9-1/2" 14 bolt GMC/Chevy rear end. This posi fits pick-ups, Blazers, Suburban's, etc. This was just taken apart, cleaned, and inspected and is in excellent ready to use condition. Asking $150 OBO.
: : Biondo Electronic Solenoid Shifter. This was used for only 2 races and then removed. This sells for $119.95 through Summit Racing before sales tax and handling fees. Comes complete with universal mounting bracket. Asking $75 OBO.
: : Dedenbear #CO2 Crossover Delay Box. This has had very little use and in excellent condition. This sells for $250 new through Summit Racing before sales tax and handling fees. Asking $160 OBO.
: : Chevy aluminum SuperRods "New in box" for Small Block Chevy. These are 6" rods with standard pin and small journal sizes. These cost $630+ but unfortunately the project these were intended for fell through and no longer have use for them. Asking $500 OBO.